- Install the Ramps 1.4 circuit board into the Arduino Mega2560
- Note: on the ramps board shown, there is only one stepper driver installed. This is for initial testing purposes
- Mount the electronics on the remaining acrylic sheet with four zip ties
- Affix the acrylic mount to the frame opposite the Y-motor mount using four zip ties
- Complete the wired connections per the following:
This blog is intended to serve as a simple, straight-forward guide for building and using your own 3D printer. I created and continually update this blog for a simple reason: the current state of 3D printing is confusing and I feel that this discourages new enthusiasts. Hopefully the simplicity of this blog will encourage more people to take the plunge into the world of reprap and 3D printing.
Pages
▼
Wednesday, September 19, 2012
Mount Electronics
Note: If you are using a Ramps DIY kit, go to http://reprap.org/wiki/RAMPS1.4 for assembly instructions.
