Friday, September 7, 2012

Affix Z-motor mount


  1. Place one M3 nut into each of the hex broaches on the two Z-motor mounts

  2. Attach a rod clamp to each of the Z-motor mounts using the following fastener assembly
    1. M3 washer
    2. M3 washer
    3. M3 nut
    4. M3 x 22 mm screw

  3. Orient the frame such that the Y-motor mount is on the far side of the unit
  4. Place one M8 washer on each of the right side protrusions of the 440 mm rods
  5. Slide one of the Z-motor mounts onto the protrusion with the well facing upward. Secure the sub-assembly using M8 washers and nuts

  6. Repeat steps 3-5 for the left side of the unit