- Install the Ramps 1.4 circuit board into the Arduino Mega2560
- Note: on the ramps board shown, there is only one stepper driver installed. This is for initial testing purposes
- Mount the electronics on the remaining acrylic sheet with four zip ties
- Affix the acrylic mount to the frame opposite the Y-motor mount using four zip ties
- Complete the wired connections per the following:
This blog is intended to serve as a simple, straight-forward guide for building and using your own 3D printer. I created and continually update this blog for a simple reason: the current state of 3D printing is confusing and I feel that this discourages new enthusiasts. Hopefully the simplicity of this blog will encourage more people to take the plunge into the world of reprap and 3D printing.
Wednesday, September 19, 2012
Mount Electronics
Note: If you are using a Ramps DIY kit, go to http://reprap.org/wiki/RAMPS1.4 for assembly instructions.