- Affix a M8 nut and a M8 washer to each side of the bar clamp rod of the Bar clamp sub-assembly
- Slide the rod into the upper holes of the open footed frame vertices
- Affix the Bar clamp sub-assembly to the frame triangle with M8 washers and nuts on both rods
- Repeat steps 1-3 for the remaining frame triangle hole, using a 295 mm (1 dot) threaded rod
This blog is intended to serve as a simple, straight-forward guide for building and using your own 3D printer. I created and continually update this blog for a simple reason: the current state of 3D printing is confusing and I feel that this discourages new enthusiasts. Hopefully the simplicity of this blog will encourage more people to take the plunge into the world of reprap and 3D printing.