Install Mechanical Endstops

1. Install one of the endstops onto the vertical smooth rod, just below the X-axis motor assembly. Use a M3x22 mm bolt, M3 washer, and M3 nut to tighten the endstop assembly
1. Note: This endstop will be adjusted during the life of the unit to ensure that the extruder assembly is properly calibrated to the heated bed
   
   
2. Install the next endstop on the horizontal smooth rod near the Y-motor. Use the same assembly process described above
   
   
   
3. Install the final endstop on the horizontal smooth rod near the X-motor. Use the same assembly process described above
   
   
   
   

<-PREVIOUS      NEXT->